6ES7132-4BF50-0AA0 ET200S, 8DO SINK OUTPUT DC24V/0,5A
SIMATIC DP, 1 ELECTRON. MODULES FOR ET 200S, 8 DO SINK OUTPUT, DC24V/0,5A, 15 MM WIDTH, 1 PIECES PER PACKAGING UNIT
| Supply voltage |
| Reverse voltage protection |
Yes; when using the same correctly polarized load voltage as on the power module |
| Load voltage L+ |
| ● Rated value (DC) |
24 V; From power module |
| ● Reverse polarity protection |
Yes |
| Input current |
| from load voltage L+ (without load), max. |
5 mA |
| from backplane bus 3.3 V DC, max. |
10 mA |
| Power loss |
| Power loss, typ. |
1.5 W |
| Address area |
| Address space per module |
| ● without packing |
1 byte |
| Digital outputs |
| Number of digital outputs |
8 |
| Short-circuit protection |
Yes |
| ● Response threshold, typ. |
1,5 A |
| Limitation of inductive shutdown voltage to |
Typ. 47 V |
| Controlling a digital input |
Yes |
| Switching capacity of the outputs |
| ● on lamp load, max. |
5 W |
| Load resistance range |
| ● lower limit |
48 Ω |
| ● upper limit |
3 400 Ω |
| Output voltage |
| ● for signal "1", min. |
Max. 1 V |
| Output current |
| ● for signal "1" rated value |
0.5 A |
| ● for signal "1" permissible range, min. |
5 mA |
| ● for signal "1" permissible range, max. |
600 mA |
| ● for signal "0" residual current, max. |
5 µA |
| Output delay with resistive load |
| ● "0" to "1", max. |
300 µs |
| ● "1" to "0", max. |
600 µs |
| Parallel switching of two outputs |
| ● for uprating |
No |
| ● for redundant control of a load |
Yes; per module |
| Switching frequency |
| ● with resistive load, max. |
100 Hz |
| ● with inductive load, max. |
0.5 Hz |
| ● on lamp load, max. |
10 Hz |
| Total current of the outputs |
| ● Current per module, max. |
4 A |
| Cable length |
| ● shielded, max. |
1 000 m |
| ● unshielded, max. |
600 m |
