6ES7132-4BB31-0AA0 ET200S, EL-MOD., 2DO ST, DC 24V, 2A, 5PC
SIMATIC DP, 5 ELECTRON. MODULES FOR ET 200S, 2 DO STANDARD DC 24V/2A, 15 MM WIDTH 5 PIECES PER PACKAGING UNIT
| Supply voltage |
| Reverse voltage protection |
Yes; when using the same load voltage as on the power module |
| Load voltage L+ |
| ● Rated value (DC) |
24 V; From power module |
| ● Reverse polarity protection |
Yes; polarity reversal can lead to the digital outputs being connected through |
| Input current |
| from load voltage L+ (without load), max. |
5 mA; Per channel |
| from backplane bus 3.3 V DC, max. |
10 mA |
| Power loss |
| Power loss, typ. |
1.4 W |
| Address area |
| Address space per module |
| ● with packing |
2 bit |
| ● without packing |
1 byte |
| Digital outputs |
| Number of digital outputs |
2 |
| Short-circuit protection |
Yes |
| ● Response threshold, typ. |
2.8 to 7.2 A |
| Limitation of inductive shutdown voltage to |
-55 to -60 V, typ. L+( ) |
| Controlling a digital input |
Yes |
| Switching capacity of the outputs |
| ● on lamp load, max. |
10 W |
| Load resistance range |
| ● lower limit |
12 Ω |
| ● upper limit |
3 400 Ω |
| Output voltage |
| ● for signal "1", min. |
L+ (-1 V) |
| Output current |
| ● for signal "1" rated value |
2 A |
| ● for signal "1" permissible range, min. |
7 mA |
| ● for signal "1" permissible range, max. |
2.4 A |
| ● for signal "0" residual current, max. |
0.5 mA |
| Output delay with resistive load |
| ● "0" to "1", max. |
200 µs |
| ● "1" to "0", max. |
1.3 ms |
| Parallel switching of two outputs |
| ● for uprating |
No |
| ● for redundant control of a load |
Yes; per module |
| Switching frequency |
| ● with resistive load, max. |
100 Hz |
| ● with inductive load, max. |
2 Hz; 0,5 H |
| ● on lamp load, max. |
10 Hz |
| Total current of the outputs |
| ● Current per module, max. |
4 A |
| Cable length |
| ● shielded, max. |
1 000 m |
